Troubleshooting
en
13
WARNING ‒ Risk of burns!
The appliance becomes hot during operation.
▶
Allow the appliance to cool down before cleaning.
Requirement:
The appliance is switched off.
1.
Clean the appliance with a damp cloth and a neutral
cleaning agent, such as washing-up liquid and wa-
ter.
2.
Dry with a soft cloth.
16.3 Cleaning the stainless steel surfaces
1.
Always remove limescale, grease, starch or albumin
stains immediately.
Corrosion may form under such stains.
2.
Clean with water and some washing-up liquid.
3.
Dry with a soft cloth.
16.4 Cleaning the glass front
▶
Clean the glass front using a glass cleaning product
and a soft cloth.
‒
Do not use any abrasive sponges that may
scratch or any glass scrapers.
16.5 Cleaning the glass plate
1.
Clean the glass plate using a glass cleaning
product and a soft cloth.
‒
Do not use any abrasive sponges that may
scratch or any glass scrapers.
2.
Dry with a soft cloth.
17 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
If the appliance is defective, call Customer Service.
WARNING ‒ Risk of electric shock!
Incorrect repairs are dangerous.
▶
Repairs to the appliance should only be carried out
by trained specialist staff.
▶
Only use genuine spare parts when repairing the
appliance.
▶
If the power cord of this appliance is damaged, it
must be replaced with a special connection cable,
which is available from the manufacturer or his Cus-
tomer Service.
17.1 Malfunctions
Fault
Cause and troubleshooting
The appliance is not
working.
The circuit breaker in the fuse box has tripped.
▶
Check the circuit breaker in the fuse box.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
1.
Open the appliance.
Following a power cut, the touch fields light up in ascending order from left to right.
The display goes out after approx. 30 seconds and the appliance is ready for operation.
2.
Start the required operating mode.
The appliance is
switched on. The op-
eration indicator does
not light up.
The operation indicator is defective.
▶
Call the after-sales service.
→
The operation indic-
ator flashes.
The appliance heats up.
▶
Wait until the appliance has finished heating up.
The cookware or
food is not heating
up.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other appliances are working.
The appliance is switched off.
▶
Switch the appliance on.
The warming drawer is not completely closed.
▶
Close the warming drawer.
The cookware covers the ventilation system slots and the appliance switches on the over-
heating protection.
1.
Wait until the appliance has cooled down.
2.
Ensure that the ventilation slots on the rear panel of the appliance are not covered.
3.
Use the main switch to switch the appliance off and back on again.
4.
Select the required operating mode and temperature.
Summary of Contents for WS46 1 2 Series
Page 1: ...en User manual and installation instructions WS46 1 2 Warming drawer Gaggenau...
Page 21: ......
Page 22: ......
Page 23: ......
