19
Installation Instructions
en-us
▯
Sink Drain Pipe:
Attach and secure drain hose as shown below in
picture “F”.
Use a standard hose clamp which can be purchased
from your local hardware store.
Minimum height of drain for installation shown above is
31.5 in. (80 cm). Maximum height of drain is 39 in. (100
cm).
NOTICE
Examples shown are for reference only. Not all fittings,
connectors, nuts, brackets, ties, etc. are supplied to
accommodate every application.
NOTICE
Ensure there are no kinks or crimps along the entire
length of hose.
NOTICE
If installed in an upper floor of a multi-story building, the
dryer should be installed on a drained floor to prevent
water damage to lower floors in the event of a leak.
Electrical Connections
Power Cord
The attached power cord is a standard NEMA 6-15P cord
and is UL approved and listed in the USA and Canada. It
meets the following requirements:
▯
208-240 volt rated;
▯
15 amps.
NOTICE
This appliance is restricted to being powered by the
supplied power cord noted above.
NOTICE
There are two allowable methods to connect the
appliance cord to power:
1.
If the home has an existing 4-prong, 30A Dryer
receptacle use the supplied Power Adapter.
Plug the adapter into the 4-prong receptacle (Line
side) and then plug the Bosch Dryer and Washer
power cords into the adapter (Load side). See
following images of Power Adapter for Line/Load side
locations and appliance cord placement.
NOTICE
This adapter can only be used with a 4-prong
receptacle. If the home has an existing 3-prong dryer
receptacle it and its complete branch circuit must be
changed to a 4-prong circuit.
2.
Use an existing individual 240V, 15A minimum branch
circuit having a NEMA 6-15R outlet (or choose to have
one installed).
PD[LQFP
PLQLQFP
)
Summary of Contents for WT262700
