44
en-us
User-maintenance instructions
5.
Pull out the Condenser cap.
6.
Remove the Condenser.
NOTICE
Do not damage the Condenser! Clean with warm
water only. Do not use hard or sharp edged objects!
7.
Rinse the Condenser and the cap on all sides with a
jet of water to completely remove all of the lint and
fluff.
8.
Remove all lint and fluff from the seals on the dryer
and Condenser.
9.
Allow the cap and the Condenser to dry fully.
10.
First insert the Condenser, then the cap.
11.
Turn back both locking levers.
12.
Close the maintenance flap until it locks into position.
13.
Look in the Troubleshooting table to reset the
maintenance indication.
Cleaning the moisture sensors
The dryer is equipped with a stainless-steel moisture
sensor. The moisture sensor measures how damp the
laundry is.
After long periods of use the moisture sensor may
become covered by a fine layer of limescale or residue of
detergents and textile care products. Such residue must
be removed regularly as the sensor function will be
impaired and the drying results less than desired.
To clean the moisture sensors:
1.
Open the door.
2.
The deposit on the sensors can easily be removed by
wiping the sensors (the two bars next to the lint filter)
with a cloth and white vinegar.
Summary of Contents for WT262700
