48
en-us
Troubleshooting
Creasing.
Laundry load exceeded.
Unsuitable program selected.
Do not exceed the maximum load for selected program.
Remove items of laundry immediately after the end of
the program, hang them up and pull into shape. Press
the center of the Program Selector to switch off the
appliance.
Select
5
(Wrinkle Block™) button to prevent the laun-
dry from creasing or wrinkling.
Drying result is not sat-
isfactory (laundry feels
too damp).
Warm laundry may feel more damp
than it really is.
Remove items of laundry immediately after the end of
the program and press the center of the Program
Selector to switch off the appliance.
The selected program does not suit
the load.
Use another drying program or, in addition, select the
time program.
Dryness level is not adjusted.
Use
·
(Level Adjust)
to adjust the dryness level.
Fine layer of limescale or detergent
and textile care products residues
on the moisture sensors.
Clean the moisture sensors.
Program termination e.g. main
power supply failure, door open or
maximum drying time reached.
See the problem(s) mentioned in this table.
Initial load is too wet.
Spin laundry at higher speed in the washing machine,
before drying.
Switch off the dryer, and then turn it on again.
Drying time too long.
Lint filter and/or Condenser is dirty. Clean lint filter
and/or Condenser.
Insufficient supply of ambient air for
cooling.
Air inlet possibly blocked.
Ensure that cool ambient room air can freely circulate
near the dryer.
Do not obstruct the air inlet on the front of the dryer.
Ambient temperature is lower than
59°F/15°C or higher than 86°F/
30°C .
Ensure the ambient room conditions are within this
range.
Program does not start
Finish in (remaining)
time is displayed.
A delayed starting time has been
selected and activated.
Drying cycle will begin at proper time to complete at
the selected Finish in time.
Program does not start
-
D
symbol lit up.
Child lock is activated.
Deactivate Child lock.
One or more indicator
lights are flashing.
Installation conditions are not ade-
quate.
Check the installation conditions.
Fault in program sequence or mal-
function.
Switch off the dryer, allow it to cool down, switch back
on and restart the program.
Power failure.
Remove laundry from the dryer immediately and spread
out. This allows the heat to dissipate. Be careful as the
door, the drum and the laundry may be hot.
Problem
Possible cause(s)
Solution(s)
Summary of Contents for WT262700
