16
English
Installing the water filter
Immerse the water filter in cold water, in a vertical position and with the
opening facing upwards. Press both sides of the filter gently to let air bubbles out.
Place the filter in the water tank, ensuring it is correctly positioned. Refill
the water tank and place it back in its compartment.
1
Press the
CLEAN/SET
clean/setting
button and then the " SETTINGS “ button.
2
Select “ WATER FILTER ” and press the “ “ button.
3
Select “ ACTIVATE ” and follow the instructions on the display to activate the
filter correctly.
Note
: you can pause the filter activation procedure by pressing the
START/STOP
START/STOP
button. To resume the filter activation procedure, press the
START/STOP
START/STOP
button again.
Remove the water filter from the water. Set the machine according to
the detected water hardness - see the “Measuring water hardness” section. On the
filter base, please set one of the following:
A
= soft water – 1 or 2 small squares
B
= hard water (standard) – 3 small squares
C
= very hard water – 4 small squares
Replacing the water filter
When the water filter runs out, the warning message appears on the
display.
1
Replace or deactivate by pressing the
CLEAN/SET
clean/setting
button and then the
“ SETTINGS ” button.
2
Select “ WATER FILTER ” then press the “ “ button.
3
Select “ REPLACE ” to change the filter or “ DEACTIVATE ” if you do not intend
to use the filter. Confirm with the “
“ button.
Follow the instructions shown on the display to activate the filter correctly.
4219-465-03661 MAN. GAG.MAGENTA PRESTIGE 120V EN-FR Rev 01.indd 16
21/01/2021 12:18:31
