1
GENERAL INSTRUCTIONS
1-1
Before starting up the appliance, carefully read the following instructions.
1-2
This appliance has been designed for professional use only and hence must only be
used by trained personnel familiar with its operation.
1-3
Keep the appliance well clear of water jets, damp areas and heat sources.
1-4
Always consult a qualified electrician for repairs and maintenance.
2
DESCRIPTION OF APPLIANCE (Fig. 1)
A)
Coffe tub lid
G)
Press
B)
Coffee tub
H)
Switch
C)
Coffee tub hatch
I)
Grinder plate
D)
Dispenser lid
L)
Body of machine
E)
Coffee dispenser
F)
Measuring lever
3
INSTRUCTIONS FOR FITTING THE BELL TO THE BODY OF THE DOSER
COFFEE-GRINDER OR COFFEE-GRINDER
3-1
The bell must be fitted before using the doser coffee-grinder or coffee-grinder.
3-2
Align the hole of the bell with one of the holes of the adjusting ring-nut (Fig. 2).
3-3
Ensure that the fan does not prevent you removing the dispenser cover or lowering
the stop pin of the adjusting disk - if it does, change holes.
3-4
Fasten, using the appropriate screw.
4
INSTALLATION
4-1
Installation must be carried out in strict compliance with the provisions of law
currently in force in the country of use, with particular reference to said country’s
accident and fire-prevention requirements and electricity authority regulations.
4-2
Before connecting the appliance to the mains supply, make sure that the voltage
indicated on the data plate is commensurate with that of the mains supply.
4-3
Carefully clean all the components (see point 7).
4-4
Make sure that the switch is off (position 0).
4-5
Insert the plug in the power inlet.
4-6
Tampering with the appliance or failure to comply with the relative connection
requirements causes undue danger and consequently renders the manufacturer’s
guarantee null and void.
5
FIRST START UP
5-1
Grind a few ounces of coffee to check the fineness of the grind.
5-2
If the grind is not to your liking, adjust the grinding system as follows:
Click adjustment (fig. 3)
- Press the fixing pin and turn the grinder in a clockwise direction for a courser grind
- Press the fixing pin and turn the grinder in an anti-clockwise direction for a finer grind
- The motor must be turned off when you do this.
Micrometric adjustment (fig.4)
- Turn the small right hand knob in an anti-clockwise direction for a courser grind
- Turn the small right hand knob in a clockwise direction for a finer grind
- The motor must be running when you do this
5-3
The numbers shown on the adjustment ring are purely indicative and could vary from
machine to machine, or when you replace the grindstone.
3
ENGLISH
ENGLISH
