25
ENGLISH
7 - MAINTENANCE AND USEFUL
ADVICE
Frequently check the filter holes (19) and remove any deposits.
Should the water have been left in the ducts for a long time, it is
necessary to allow some water to flow through them in order to
remove any deposits.
It is a good idea to rinse the filters (19) and filter holders (16) every
day in hot water.
It is advisable to leave the filter-holder cups inserted with the
coffee dregs for the entire working day to ensure that the filter-
holder is always at optimum temperature.
Do not use any abrasive or corrosive products for cleaning the
bodywork.
The steam nozzles must be cleaned immediately after use in
order to prevent the risk of the formation of any scale which may
block the holes and to ensure that any drinks made subsequently
do not absorb any unpleasant odours.
16
FILTER HOLDER
17
SPOUT HOLDER
18
SPOUT
19
FILTERS
20
SEAL
21
UNIT
22
SCREW
23
ALLEN SCREW
Fig.7.01
Below-cup seal replacement
Seal (20) needs to be replaced in the event that coffee leakage is
noted between unit (21) and filter-holder (16), or in the event that
on closing filter holder (16) the unit centre is greatly exceeded.
Remove the spout (18) by loosening the central screw (22).
Remove the spout holder (17) by loosening the two Allen screws
(23).
Then proceed to remove seal (20) using a screw driver.
After removing the seal undertake to clean the slot and then re-
assemble the new seal taking care to insert it with the chamfered
part turned upwards towards the unit itself.
Summary of Contents for TS
Page 60: ...MARRONE BROWN ...
