GAH Electrastream User And Installation Manual Download

Page: 36 / 56

Important Health and Safety Information for Installers and Service Engineers

Health and Safety at Work Act 1974
Consumer Protection Act 1987
COSHH Regulations 1988
The following information is given as a requirement of the
above legislation.
Great care is taken by GAH (HEATING PRODUCTS) LIMITED
to ensure that Electrastream systems are designed and
manufactured to meet general safety requirements when
properly used and installed as recommended in this manual.
It is the responsibility of Users and Engineers to ensure that
adequate protective clothing and glasses are worn when
working with the Electrastream system.

SEALS AND INSULATION

SEALS AND INSULATION
Insulation and sealing materials are used in the construction
of the Electrastream cylinders. Units are sealed and when
used in the manner for which they are intended the insulating
and sealing materials do not present any known hazard.
However always observe the following recommendations:-
1. Avoid inhalation of fibres or dust, wear face mask.
2. Avoid eye contamination by fibres or dust - wear eye
protection.
3. As far as possible avoid any skin contact with Fibreglass
Insulation, Glass Rope, Mineral Wool, Insulation Pads and
Ceramic Fibre.

PPPPPatent application 01514800.2

atent application 01514800.2

2010 GAH (HEATING PRODUCTS) L

2010 GAH (HEATING PRODUCTS) LTD.

TD.

Electrastr

Electrastream is a T

eam is a T

eam is a Trademark of GAH (HEATING PRODUCTS) L

rademark of GAH (HEATING PRODUCTS) L

rademark of GAH (HEATING PRODUCTS) LTD.

TD.

Manual by Harber Technical Services Tel/Fax 01263 515444

E-mail:info@harbertech.co.uk www.harbertech.co.uk

GAH (Heating Pr

GAH (Heating Products) Ltd.

oducts) Ltd.

Building 846
Bentwaters Parks
Rendlesham
Woodbridge
Suffolk IP12 2TW

TTTTTel:

el:

el: 01394 421160

01394 421160

Fax:

Fax: 01394 421170

01394 421170

email: mail@gah.co.uk
www.gah.co.uk

In pursuance of a policy of constant development, GAH (HEATING PRODUCTS) LIMITED
reserve the right to change Electrastream parts or design without notice, therefore
certain details included in this manual may not be correct at the time of printing. Any
modification and improvements detailed in this manual does not commit GAH to update
any system previously supplied.

Manual Part No. ...................MAN1019
Manual Ref ..........................ES02
Issue ...................................13
Date ....................................25/02/13

GAH (HEATING PRODUCTS) LIMITED will not accept

responsibility for any damage or personal injury caused

by not giving due consideration to the above safety

recommendations.

OTHER MATERIALS

SEALANTS, ADHESIVES AND PAINTS

Sealants, Adhesives and Paints are used in the construction of
the Electrastream components. When used in the manner for
which they are intended they do not present any known hazard.

ELECTRIC

ELECTRIC
The Cylinder Tri-Core Heater, Pump, Thermostats and Contactor
Box all have electrical supply of 230V (enough to endanger
life).
Always isolate before connection, adjustment, servicing and
repair.
When the Tri-Core Heater cover is removed high power live
electrical terminals are exposed.
ISOLATE THE TRI-CORE HEATER BEFORE REMOVING ITS
COVER.
Earth protection - Earth Continuity Conductors must be fitted
and must comply with IEE Wiring Regulations.

HTS REF GAH ELECTRASTREAM 25/02/13

HEAL

HEALTH & SAFETY

TH & SAFETY

INST

INSTALLA

ALLA

ALLATION 4

TION 4

4-3.11 Cylinder Drain

See fig. 4-3.e.
The unvented cylinder cold feed is also used as the cylinder drain. Inside the cylinder a
syphon pipe is fitted; when a hose is used to drain the cylinder a syphon action will drain
maximum water from the cylinder.
Always use a hose for flushing and cleaning the cylinder.
It is not possible to fully drain the cylinder without using a hose.

4-3.12 Secondary Return

A secondary return may be fitted to unvented cylinders (consult the label on the face of
the unit for the correct location). A *non-return valve must be fitted to prevent back flow
and a *bronze pump will be required in conjunction with a *pipe thermostat and timer to
circulate the hot water (*not supplied).

Note
An extra expansion vessel may be required where the additional volume of the secondary return exceeds
the capacity of the expansion vessel supplied.

Fig. 4-3e Cylinder Drain

44444