Operation
IPE2500A and IPE2500A-MLS Paging Encoder/Desktop Controller
03/12 14
Front Panel Buttons
Signaling Buttons
The signaling buttons operate as follows:
ALERT
The
ALERT
button is used to transmit two types of alert tones: a continuous tone and a pulsed tone (when
used in conjunction with the
CTL
button.) Refer to the “Alert Tone” section on page 23 of this manual
for a detailed description.
PAGE
The
PAGE
button is used to enter page mode. While in page mode, the operator may select from among
various types of pages to be transmitted. These include DTMF, 2-Tone, Plectron, 5/6-Tone, 2805, 1500,
and Immediate DTMF. Refer to the “Paging” section on page 24 of this manual for a detailed
description.
CLEAR
The
CLEAR
button uses include clearing the frequency selection during frequency selection mode or
clearing a capcode entry in paging mode.
SELECT
The
SELECT
button is used to enter the frequency selection mode (not possible on the IPE2500A-MLS),
select a frequency in frequency selection mode or select a paging type in page mode.
UP/DOWN
BUTTONS
The
UP
and
DOWN
buttons are used while in the paging mode to scroll through the pre-programmed
paging aliases and for programming microphone sensitivity.
PB1, PB2, PB3, and PB4 Programmable Buttons
The four programmable buttons with LED indicators are used to custom configure up to eight user
functions. The
PB1
through
PB4
buttons are accessed directly, while the
PB5
to
PB8
buttons are
accessed using the
CTL
key while depressing one of the
PB1
through
PB4
buttons. When shipped from
the factory, the programmable buttons are disabled. Refer to you CARD Suite Help file for programming
information.
In addition, the use and function of these keys are dependent upon your radio’s capabilities.
VOLUME Up and VOLUME Down Buttons
Press the
VOLUME
Up or Down buttons to adjust the local speaker volume if the handset is on-hook.
The handset speaker volume is adjusted if the handset is off-hook.
The display shows the new setting for two seconds after a volume change. The internal, handset, and
accessory each have individual settings. When the handset is off-hook, the following message is
displayed:
HANDSET
VOL:
X
(handset off-hook)
SPEAKER
VOL:
X
(handset on-hook)
The
VOLUME
Up and
VOLUME
Down buttons also adjust the sensitivity of the microphone that is
currently in use. Refer to the “Microphone Sensitivity Adjustments” section on page 44 of this manual
for more information.
Summary of Contents for IPE2500A
