Titan Illuminated Crossing Telephone
8
Figure 9 – Gland assembly
IMPORTANT
: If only one gland entry is used, the blanking plug fitted to the
second gland position must be left in place.
3.2 Pole Mounting
Kit No 100-02-0208-001
For mounting telephones on to the side of round poles of 100mm to 200mm
diameter, or on to square or rectangular section uprights of 100mm to 150mm
across the mounting surface.
Banding straps (large-scale worm drive clamps) are not included in this kit and
must be obtained separately. For details of where these may be obtained call
GAI-Tronics.
For flat mounting on surfaces greater than 150mm across, use the Vertical
Surface or Wall Mounting
method.
Figure 10 – Pole mounting
1. Disassemble the telephone as described in
Vertical Surface or Wall
Mounting
.
2. Punch through the flanged bushes in the rear enclosure - taking care to note
the
IMPORTANT
advice in Vertical Surface or Wall Mounting regarding
extra holes and warranty invalidation.
3. Attach the pole mounting clamp assemblies to the rear enclosure using the
M6 x 25 screws provided - see Figure 14 – Pole mounting.