WARNING:
During use, make sure that the parents bed sheets,
blankets etc. do not enter and cover the interior of the crib.
I n order to fix the crib to the parents bed (Co-Sleeper Adapter mode) use the pair
of straps provided. Fix the straps around the structure of the parent's bed, from
the bottom towards the top and fix the buckle to form a loop. Repeat this
operation on the other side. For easier installation, during fixing of the buckles, we
suggest that the crib is kept at a short distance from the parent's bed. At this point,
move the crib to the side of the parent's bed and tighten the loop by pulling the
belts firmly. Carry out this operation on one side and then on the other side,
adjusting the belts until the crib is firmly in contact with the parents mattress.
WARNING: before every use always check to make sure that there is no more than
1/2"/
gap between the parent's mattress and the side of the crib. If there is, pull
the belts firmly to tighten until there's no space and the permitted condition of use
has been restored.
WARNING:
When the product is used in the "Co-Sleeping Crib Mode"
{textile panel open
/ fixing to the bed) it should always be fitted to the
long side of access to the bed. DO NOT fix the product to the head or
bottom of the bed.
12
