2X3 BAND TUBE EQUALIZER
!
LOW FREQUENCY BAND
One of the features of the
fi
lter
networks is that the device is able to
cut and boost at the selected
frequency at the same time, thus can
realizing complex transmission
characteristics. To boost, select the
desired frequency using the FREQ (Hz)
switch. Set the LOW CUT (dB)
parameter to OFF (0). Use the LOW
BOOST (dB) parameter to adjust the
amount of increase.
To cut, select the desired frequency
using the FREQ (Hz) switch. Set the
LOW BOOST (dB) parameter to OFF
(0). Use the LOW CUT (dB) parameter
to set the cut rate. For complex
transmission curve. select the desired
frequency using the FREQ (Hz) switch. Use the LOW BOOST (dB) parameter to set
the amount of increase. Use the LOW CUT (dB) parameter to set the cut rate.
BOOST SHIFT
In connection with simultaneous cutting and bosting, the BOOST
SHIFT function has been added to the device, which is able to shift
the boosted frequency proportionally to the cutting frequency
during operation, enriching the process of creating a complex
transmission curve with additional possibilities. To turn on the
function, set the switch to the down position. To deactivate the
function, set the switch to the upper position.
Attention! The degree of frequency
shift depends on the selected frequency!
!
!
5
