2X3 BAND TUBE EQUALIZER
!
HIGH FREQUENCY BAND
One of the features of the
fi
lter
networks, the device is able to cut
and boost at the selected frequency
at the same time, thus realizing
complex transmission characteristics.
To b o o s t , s e l e c t t h e d e s i re d
frequency using the FREQ (Hz) switch.
Set the HIGH CUT (dB) parameter to
OFF (0). Use the HIGH BOOST (dB)
parameter to adjust the amount of
increase.
To cut, select the desired frequency
using the FREQ (Hz) switch. Set the
HIGH BOOST (dB) parameter to OFF
(0). Use the HIGH CUT (dB) parameter
to set the cut rate. For complex
transmission curve. select the desired
frequency using the FREQ (Hz) switch. Use the HIGH BOOST (dB) parameter to
adjust the amount of increase. Use the HIGH CUT (dB) parameter to set the cut
rate.
CUT SHIFT
In connection with simultaneous cutting and boosting, the CUT
SHIFT function has been added to the device, which is able to shift
the cutting frequency in proportion to the boosting frequency
during operation, enriching the process of creating a complex
transmission curve with additional possibilities. To turn on the
function, set the switch to the down position. To deactivate the function, set the
switch to the upper position.
Attention! The degree of frequency shift depends on
the selected frequency!
!
!
7
