8
Malvern manual version 1.0 S.D 25.4.2014
Your Malvern bath is simple to use. However there are some basic guidelines which should be followed to
ensure you get the most of your unit.
The handset control push buttons use air to operate the seat, therefore it is completely
safe to use with wet hands.
The handset buttons operate independently on a depress to run basis. If the button is
released the unit will stop.
Holding down one button and then pressing the other will cause the unit to stop.
MAXIMUM USER WEIGHT IS 150 KG or 140 KG if using a Transfer system.
A safety lap belt is provided with your product. This is to be used at all times when the unit is operated with
a seated user.
The bath lift is independent to the seat. To raise the bath the seat must be inside the
bath in the raised position.
NOTE: the bath will not raise when the seat is outside the bath.
The bath can be raised to a comfortable height to suit the user.
The bath raises and lowers on a keypad. Pressing both buttons at the same time will
cause the bath to stop. Releasing either button will enable the bath to continue.
When not in use the bath should be fully lowered.
To open and close the waste, use the
Control knob located on the top edge of
the bath tub. The waste will open and
close on a half turn.
To operate the spout, open the valve marked “spout”. This is
pre set to 42°C.
Some products have a third valve fitted to add cold water only
(specified models only).