Single Site Programmer User Guide
1
GS-SNG-SITE-PRG-UG-001240
Page 23 of 30
Release 1.0
For the GS1011MxxS
To populate the Single Site Programmer board with the modules, perform the following:
1.
Before populating the site you must power off the board; every time.
2.
Insert a module with the logo/product label facing up and the module pins aligned with the pogo
pins into the socket site (see
Figure 10: Inserting the GS1011MxxS Module into the Socket Site
3.
Once the module is loaded into the socket site, close the cover gently to ensure there is even
pressure on the site to make a good pin contact.
CAUTION!
Proper care must be taken when closing the cover on the module socket site.
Excessive force will result in the module getting damaged.
