GALA ELECTRONICS 300 T
GALA ELECTRONICS 300 T
GALA ELECTRONICS 300 T
GALA ELECTRONICS 300 T
E
E
E
E
GB
GB
GB
GB
0
39
12
JOBS MANAGEMENT
Personalised welding settings, or JOBs, can be saved in memory locations and subsequently uploaded.
Up to 50 jobs can be saved (j01-j50).
The settings of the SETUP menu are not saved.
A.
SAVING A JOB
This function is available when welding mode is not active.
S5
Hold down the button for 3 seconds.
JOB STORAGE SELECTION
The message appears on the following displays: D2
S5
Press the button to confirm.
STORE JOB N.xx
The message appears on the following displays: D2
xx=
number of the first free job.
JOB MEMORY FULL
When there are no free memory locations the message appears on the following displays: D2
E1
Use the encoder to select the required job number.
On selecting a currently occupied memory location, the job number flashes.
If you confirm at this point, the new job will overwrite the previously saved settings.
Exit without confirmation
Press any button (except S2).
This action will automatically close the menu.
Exit with confirmation
S2
Press the button.
This action will automatically close the menu.
B.
LOADING A USER JOB OF FACTORY SET JOB
This function is available when welding mode is not active.
S2
Press and release the button.
LOAD JOB N.xx
Only when the jobs have been uploaded, the message is shown on the following displays: D2
xx=
number of the latest job used.
NO JOB LOADED
If there are no jobs in the memory the message is shown on the following displays: D2
E1
Use the encoder to select the number of the job to be uploaded.
Exit without confirmation
Press any button (except S2).
This action will automatically close the menu.
Exit with confirmation
S2
Press the button.
LOADED JOB N.xx
The message appears on the following displays: D2
This action will automatically close the menu.
When a job is loaded and an UP/DOWN torch is installed, press the torch triggers to select the saved jobs.
C.
DELETING A JOB
This function is available when welding mode is not active.
S2
Hold down the button for 3 seconds.
JOB STORAGE SELECTION
The message appears on the following displays: D2
E1
Select the following setting with the encoder:
JOB ERASURE SELECTION
The message appears only if there are saved JOBS, on the following displays: D2
S2
Press the button to confirm.
ERASE JOB N.xx
The message appears on the following displays: D2
xx=
number of the latest job used.
NO STORED JOB
The message appears only if there are saved JOBS, on the following displays: D2
E1
Use the encoder to select the number of the job to be deleted.
