GALA MIG (V. COMPACTA). Manuel d'Instructions
12
1.1. ACCESSORIES.
A series of accessories are required to correctly install the equipment and use it appropriately. These must
be chosen in agreement with the table below.
Accessories included in the
GALA MIG
series equipment.
GALA MIG 1810
GALA MIG 2300 ALU 4R
GALA MIG 2600
GALA MIG 2600
Earth cable.
L=4 m. S=25 mm
2
Ref. 437.12.219 (X)
L= 4 m; S= 35 mm
2
Ref. 438.12.219
L= 4 m; S= 35 mm
2
Ref. 438.12.219
Wire drive rollers.
0.8-1.0 mm
∅
40-”V”
Ref. 49416022
0.8-1.0 mm
∅
30-”V”
Ref. 49216022
1.0-12 mm
∅
30-”U”
Ref. 62006021
0.8-1.0 mm
∅
40-”V”
Ref. 49416022
0.8-1.0 mm
∅
40-”V”
Ref. 49416022
Protection hand screen.
MINIMUM PROTECTION TONE 11. (HAND SCREEN Ref. 675.00.03)
Recommended accessories.
GALA MIG 1810
GALA MIG 2300 ALU 4R
GALA MIG 2600
GALA MIG 4000
Recommended torch.
MX-15 ; 150 A/60%
MX-25 ; 200 A/60%
MX-25 ; 200 A/60%
MX-25; 200 A/60%
MX-36; 300 A/60%
MX-36; 300 A/60%
Recommended pressure reducing valve.
315 Kg./cm
2
28 L/min. (MOD. EN-2 Ar-CO
2
- Ref. 376.00.000)
Gas economiser system.
ARGON-MIX (ECNONOGALA MOD. Ref. 355.00.000)
Maxima Torch
Welding intensity
Reference Model
100 %
60 % 35%
Wire Ø
(Recommended)
215.00.004 MX-15 115 150 195
0.6 - 0,8 mm
225.00.004
MX-25
155
200
260
0,8 - 1 mm
236.00.004 MX-36 235 300 395
1 - 1,2 mm.
EN-2 Ar-CO2 Ref: 376.00.000
INTAKE PRESSURE (bar)
200
OUTLET PRESSURE (bar)
10
NORMAL FLOW Q
1
20 Nl/ min
MAXIMUM FLOW Q
maz
28 Nl/ min
ECONOGALA REF: 355.00.000
The Econogala economiser valve is capable of saving up to 50% of the
consumption of any welding shielding gas, use in MIG-MAG-TIG procedures.
In case of spot welding it is possible to be obtained up to a 50% of saving, in
the welds of long joints the saving can be around 20%.
It is easy and simple to install, not needing any type of special coupling. It
must be next to a pressure reducing valve with single expansion chamber.
FOR THE USE OF ANY OTHER ACCESSORY CONSULT THE MANUFACTURER.
Summary of Contents for 53100000
Page 39: ......
