GALA MIG (V. COMPACTA). Manuel d'Instructions
13
2. TRANSPORT AND INSTALLATION.
Knocks and sudden movements must be avoided when transporting the equipment. The transport position
will be shown by arrows on the packaging. In any case, the packaging must be protected from water.
Once the equipment has been unpacked the wheels must be mounted:
1º
11º
9º
10º
12º
8º
5º
6º
2º
4º
3º
7º
5º
6º
2º
4º
3º
7º
The welding equipment location must satisfy the following requirements:
Place: Dry and ventilated, far enough away from the cutting area in order to prevent the metal dust caused
by the cutting process from getting into the equipment.
Electrical installation. Electrical elements of the installation.
Protection system
GALA MIG 1810
GALA MIG 2300 ALU
GALA MIG 2600
GALA MIG 4000
16A 2P + T
16A 3P + T
32A 3P + T - 230V
16A 3P + T - 400V
32A 3P + T - 230V
16A 3P + T - 400V
Connection
plug.
DO NOT FORGET TO FIT THE EARTH CONNECTION INTO THE PLUG.
Magnetothermal
switch (Curve
“D”)
2P 20 A 230V
3P 15 A - 230V
3P 10 A - 400V
3P 20 A - 230V
3P 15 A - 400V
3P 25 A - 230V
3P 20 A - 400V
Differential
circuit breaker.
(Minimum)
2P 25A/300 mA
3P 25A/300 mA
3P 25A/300 mA
3P 25A/300 mA
Power supply hose (RVK-1KV).
GALA MIG 1810
GALA MIG 2300 ALU 4R
GALA MIG 2600
GALA MIG 4000
Length
230 V
400 V
230 V
400 V
230 V
400 V
230 V
400 V
10 m
4 mm
2
2.5
mm
2
2.5
mm
2
2.5
mm
2
2.5
mm
2
2.5
mm
2
4
mm
2
4
mm
2
15-20 m
6 mm
2
4
mm
2
4
mm
2
2.5
mm
2
4
mm
2
4
mm
2
6
mm
2
4
mm
2
When the equipment leaves the factory it is tagged with the voltage of use that has been selected internally.
In dual-voltage three-phase equipment the voltage can be changed by accessing the inside of the equipment.
Remove the side panel. On the inside you will find a connection card (this is protected with a plastic cover).
Make the machine connection as shown in the Figure.
Voltage change system.
STANDARD EQUIPMENT (230/400 V)
SPECIAL EQUIPMENT (220/440 V)
230 V
400 V
220 V
440 V
GALA MIG
1810 – 2300 ALU
- 2600
GALA MIG
4000
Summary of Contents for 53100000
Page 39: ......
