M
15/49
Gala Gar, S.L. c/ Jaime Ferrán, 19 (Políg. Cogullada) | Tel.: (+34) 976 47 34 10 - 50014 ZARAGOZA |
Smart 120 Mini Syner
2. TRANSPORT AND INSTALLATION.
2.1. TRANSPORT AND PACKAGING
Avoid shocks and sudden movements when transporting the device. The packaging must be protected from
falling water.
HANDLE THE EQUIPMENT WITH CARE, IT WILL EXTEND ITS LIFE!
2.2. ELECTRICAL POWER SUPPLY INSTALLATION.
The electrical installation of the equipment that makes up the system must be carried out by specialised
personnel in accordance with the standards in force.
The site shall meet the following requirements:
-
Location: Dry and ventilated. Sufficiently far away from the welding station in order to prevent dust and
pollution from the work process from entering the equipment. Never work in the rain.
-
The switchboard where the machine is to be connected must consist of at least the following elements:
DIFFERENTIAL SWITCH (ID): Two-pole or three-pole with a minimum sensitivity of 300 mA. The purpose of
this device is to protect people from direct or indirect contact with live electrical parts. The differential
switch is selected according to the nameplate.
AUTOMATIC SWITCH (IA): Two-pole. The device shall be chosen according to the nameplate
.
The mains connection is made via the inlet hose. IMPORTANT! Make sure that the cable is connected to an
effectively earthed socket.
-
If the use of a longer supply hose or connection to
an extension cable is necessary, please observe
the values in this table. These values are
approximate and are influenced by the condition
of the conductors, the connections and the
ambient temperature.
Length
SECTION
5 m
2.5 mm
2
Up to 15 m
4 mm
2
> 15 m Up to 50 m
6 mm
2
ELECTRICAL INSTALLATIONS MAY ONLY BE OPERATED BY QUALIFIED PERSONNEL.
BEFORE SWITCHING ON THE EQUIPMENT, CHECK THAT THE ELECTRODE
CLAMP IS SEPARATED FROM THE WELDING GROUND.
