USAGE
U
S
A
G
E
1.Please move the lampshade and the thermostat out 3-5mm
in the direction of the arrow.
2.Take out the lamp shade and thermostat downwards.
the arrow.
3.Pull the connection terminal, use the screwdriver to remove
the LED light board and replace it.
Note:
If the LED lamp is abnormal, it should be
replaced by professionals. Do not take dismantling
and replace it privately in order to avoid damage.
NON-FAULT PHENOMENON
Condensation of appearance: When the humidity of the
surrounding of refrigerator is large, the condensation on the
surface of the cabinet is a normal phenomenon.
The heating of both sides of the cabinet and the frame
around the door of freezing chamber: The heating will be
obvious in start-up operation and summer. This is the
normal work of the refrigerator, and there is no effect on the
food in the cabinet.
Long-term operation of compressor: When the refrigerator
is first used, it takes a long time to work to reduce the
temperature to a set value, and the compressor will run
intermittently after the stable operation of refrigerator.
Surface heating when the compressor is running: When the
compressor works normally, the surface temperature is high,
which is a normal phenomenon. Do not touch it with your
hands.
The sound of flowing water: It is a normal phenomenon for the
sound of refrigerant flowing in the pipeline.
The sound of evaporator and piping: When the refrigerator
runs, with changeable temperature, evaporator and pipe will
make a sound due to thermal expansion and contraction.
Overheat alarm of freezing room: It is caused by high
temperature inside the cabinet for the first electrification. The
alarm will be automatically cancelled when the temperature
drops.
19
