Galaxy Audio Any Spot QUAD, User Manual

G. Trouble Shooting:

1. LED doesn't light when power switch is pressed to turn on mic.

    a. Make sure 

that the 

batteries are not discharged.

    b. Make sure 

that the 

batteries are installed correctly.

2. LCD shows                      when power switch is pressed to turn mic off.
    

a. 

3. LCD panel shows unusual indications.

    a. Remove the batteries from the microphone and re-install them.

4. No audio from microphone.

    a. Check 

that 

the frequency of the transmitter is the same as that of the receiver.

    b Make sure 

that the 

Mic switch is not set to Mute.

    c Check if the distance between the transmitter and the receiver is too great.
    d Check if the transmitter or the receiver is too close to any large metal objects.

5. Interference and signal Disturbance

.

    a. Make sure there are no other wireless systems operating on the same 
        frequency in the same area.  This includes Microphones, televisions, radio 
        stations, etc.  Try setting the transmitter and receiver to a new channel.

H. Q&A

1. 

Q:

 How long can the microphone be operated with fully charged batteries? 

A: 

Re-chargeable batteries will last approximately 8 to 10 hours. Disposable

         batteries will last approximately 13 hours.
    

Q:

 How much time is required to recharge batteries from a fully exhausted 

         state?
    

A:

 Approximately 4 to 5 hours.

Press  the  SET, UP and DOWN buttons at the same time in order to turn 

         the microphone off automatically. 

The LCD display will flash about ten times 

         and then the microphone will turn off automatically. The microphone should 
         now turn on and off normally.
    b. If the problem persists, call for service.

. 

. 

. 

9

10

4. Press the Down button to display a lower numbered channel.

5. Press the SET button to activate the selected channel.

E. Battery Indications:

1.                     :Three bars means batteries are fully charged.

2.                     :One bar indicates low batteries. 

R

eplace or recharge the 

                         batteries.

3.                     :No bars showing indicates batteries are exhausted and after 
                         flashing three times the power will automatically shut off.

F. Battery Charging Steps:

1. Rechargeable batteries need to be NiMH AA 1.2V with an amperage of
    2100mAH or less as the  charging function is limited to  batteries of that
    rating.

2. Recharging is best accomplished by using the AS-TV8DCC  charger

3. Charging status:

a.                     Battery indicator flashing: Non-Rechargeable batteries installed or 
                        no batteries installed. 

Check the 

batteries.

b.                     Battery indicator is flashing and LCD backlight is on: Failing,
                        corroded, or over-temperature batteries.

c.                     One or two bars showing: Batteries are charging successfully.

d.                     Three bars showing: Batteries have been fully charged.

* Please note the microphone will be turned off automatically while it is being 
   charged.