Limiter sub-menu –
from this page it is possible to set the Output Channels Limiter.
The following is an example screen for the Limiter page where the Attack Time of the Limiter is
set at 5ms, the Release Time is set at 0.2Sec and the Limiter Active Threshold is set at +5dB:
Once pushing ENTER the Limiter's parameters can be modified using the “NAV/PM1”, “PM2” and
“PM3” encoders for editing the Limiter's Attack Time [A], Release Time [R] and Active Threshold.
Once pushing ENTER the above screen will change as follows:
The Attack Time [A] can be edited using the “NAV/PM1” encoder, the Release Time [R] the “PM2”
encoder and the Limiter Active Threshold the “PM3”
“
Attack Time [A]
”: the selectable range of the Limiter's Attack Time is from 5ms to 200ms in steps
of 1ms - from 5ms to 20ms, then 5ms - from 20ms to 30ms, then 10ms - from 30ms to 100ms, and
20ms - from 100ms to 200ms.
The Limiter's Attack Time can be adjusted by rotating the “NAV/PM1” encoder.
“
Release Time [R]
”: the selectable range of the Limiter's Release Time is from 0.1s to 3s in steps
of 0.1s and can be adjusted by rotating the “PM2” encoder.
“
Limiter Active Threshold
” : the selectable range of the Limiter's Threshold is from +20dB
(Limiter not active) to -10.0dB in steps of 0.2 dB and can be adjusted by rotating the “PM3”
encoder.
Note1:
Once the desired options have been selected using the 3 encoders, they are automatically
saved as current and stored in the DS-SP24 system status once leaving the page.
Note2:
To exit this page, push the “ESC” button.
Delay page –
from this page it is possible to set the Output Channels Delay Time from 000.0000mS
up to 848.9984mS, by steps of 1mS or 20.8uS.
To set the Delay time press ENTER an arrow will appear on the left of the screen “->”. Then use the
“PM2” encoder to set the Delay Time in steps of 1mS and the “PM3”, for setting the “fine” Delay
Time in steps of 20.8 microseconds.
The following is an example screen for the “Delay” page where the Delay Time of Output Channel 1
is set to 160.1872mS:
Out-1 Name Limiter
A: 5ms R: 0.2s +5.0dB
Out-1 Name Limiter
-> A: 5ms R: 0.2s +5.0dB
Out-1 Name Delay
-> Delay = 160.187mS
25
