Polarity page –
from this page it is possible to set the Output Channels Polarity, by using the
“PM1” or “PM2” encoders.
The polarity can be “Normal” or “Inverted” (which means rotated of 180 Degrees).
The following is an example of a “Polarity” screen where the Polarity of Output Channel 1 is set to
“Normal”
● Input and Output Channels Last Edited Parameter Return Function
Once you have escaped out of parameter editing within the individual Input or Output channels the
DS-SP24 will remember this last editing action on that Channel. When you return for your next
editing action pressing the EDIT button on that channel will immediately return you to the screen
related to this last editing action.
This function makes fine tuning or modifying easier when it is necessary to make a number of
adjustments to the same parameter in a short time sequence.
● Input Channels and output Channels LINK Function
The DS-SP24 is able to perform a unique LINK MODE between Input Channels as well as a link
between Output Channels to enable quick and immediate editing (you cannot link output to input
channels).
To link channels when editing, you will need to select a “Master” channel that will be the one to be
edited and have it’s parameters displayed on the LCD screen. You can then select and link other
channels (Slaves) that you wish to apply the same changes to.
To enter a link mode session, select the Master channel Edit mode, then link the Slaves by
pressing their related Edit buttons.
All Linked channels will be selected ready for adjustment when their “Blue” LED is lit in the Editing
mode.
Now all Slave channels and only those selected will modify their parameters accordingly as you
edit the Master channel.
All other existing parameters will stay the same within the Slave Channels unless edited by this
link with the Master channel.
Note:
The LINK function is NOT a COPY function.
If you want to edit the limiter of the Output channels 1, 2, 3 and 4, you can enter the editing mode of
Output Channel 1 by pressing the related Edit button and turning on the “Blue” LED below the
Output Channel 1 LED meters. This assigns the “role” of Master and displays this channel’s
Parameters on the LCD:
Out-1 Name Polarity
-> Polarity = Normal
Out-1 Name Limiter
A: 5ms R: 0.2s +5.0dB
26
