Page 15
MOUNTING PROCEDURE:
PREVIEW:
After evaluating the mounting surfaces and obtaining
the appropriate fasteners, the installation will consist of the
following steps, in order:
1. Mounting the bracket plate to the wall or ceiling.
2. Bolting the yoke to the plate.
3. Joining the cabinet with the bracket assembly.
4. Installing the safety cable.
5. Adjusting the speaker position and tightening the yoke
bolt and wing screws.
TOOLS REQUIRED:
You will need at least these tools for
installation:
7/16" box end wrench
large crimping pliers
tools to secure the fasteners selected for the bracket
assembly (drill, screwdrivers, etc.)
carpenter's level for precise positioning of the speaker.
(optional)
Note: It is often helpful to have another person available to
hold the speaker in place during the tightening procedure.
INSTALLATION:
ATTACHING THE BRACKET ASSEMBLY TO THE MOUNTING
SURFACE:
Position the bracket assembly onto the wall or ceiling at the
location you have selected, preferably to a stud, joist or other
structural member rather than only to drywall or other non-
structural material. Make sure there will be enough clearance to
rotate and tilt the speaker to the desired angle. Using the base
plate of the bracket assembly as a template, mark the four hole
locations.
NOTE: Check that any holes you drill and the fasteners will
not interfere with any wiring, plumbing, etc. that may be
behind the mounting surface.
Prepare the mounting surface and the four holes for the fasteners.
