Troubleshooting:
The power cord is not
plugged in properly
Push power cord thoroughly into the power outlet
The cover is open
Close cover
No-Staple light is ON Re-fill Staples. Follow instrictions on page 4.
Papers are not in
Paper-in tray
Place paper in Paper-In Tray and align to the Left &
Right Side Guides
Staples jam
1. Remove jammed staples. Follow instructions on
Page 3.
2. Always use our 26/6 or 26/8 standard staples.
3. Check if the Staples Pusher is scratched or worn
out. Follow the instructions on page 3 to put in a new
Staple Pusher.
Paper jam
1. To remove jammed sheets, press the “REVERSE”
button on the control panel to drive the paper
backward. You may need to press it a few times
until it stops, then you can pull out jammed sheets.
2. Do not insert more than 16 sheets of paper.
3. Do not insert materials that are too thick or too
rigid. Do not insert materials other than paper.
Black (Dark coloured)
covers
If possible, avoid using black or dark coloured
covers as the infrared sensor may not be able to
detect sheets being inserted into the machine.
If the machine is switched on but won’t work at all:
If the machine doesn’t staple although the staple magazines are fully
filled with staples:
Staple Pusher is not
hinged on the pin
The hole on the Staple Pusher should be hinged
onto the pin. Follow instructions on Page 3.
Staple Pusher is
missing or incorrectly
positioned
Follow instructions on Page 3 to put in the Staple
Pusher. The mark “26” should be shown towards
the rear of the machine and the Staple Head latch
should be locked.
10
