18
Instructions
Step 1.
The cover lifter must be assembled to the dimensions of
your spa.
If your spa is square, you can choose the orientation of
your cover and the side on which you install the lifter.
The framing tubes are slidable. Use your spa dimensions
and add 5cm on each side to allow space for movement,
as indicated by the table below. This is explained further
in step 5.
Note, If your spa is rectangular, install the cover lifter on
the shortest side (the width).
Spa Pool Model
Spa Pool Dimensions
(length x width x depth)
Total Cover Lifter Width
Draco I
2m x 2m x 0.82
200cm + 10cm = 210cm
Ara I
2m x 2m x 0.82
200cm + 10cm = 210cm
Step 2.
Place the
base brackets on the ground with the flat
side facing the spa. You can either slide them under the
base of the spa or prop your empty spa up slightly.
Note, it does not matter exactly where they are placed,
as long as they are square to the spa, as a tube will go
through them.
