26
Hardwiring
There are two ways to hardwire the spa power cable to your house power supply:
Cabinet Power Feed Concealed
Power Feed
The power cable is fed through the cabinet
by drilling through the closest panel to your
outdoor point and inserting a grommet. The
cable is then run from the power source,
through the cabinet, to the spa controller.
Power cord
Concealed Power Feed
If you wish to conceal the power cable, instead
feeding it through the bottom of the spa, the
initial wiring and conduit will need to be in
place before delivery. Ensure your cable comes
up underneath the spa in the suggested input
location, as shown in the following diagrams.
When the spa arrives, have it lowered onto
supporting blocks or ice bags and open the
cabinet panel. Feed the cable up through
the hole into the inside and then remove the
blocks and lower gently onto the foundation.
Power cord
Installation Guides for Your Electrician
Installation guides for your specific control system can be found on the
on our
website. Please ensure your electrician has a copy of this guide and the relevant controller
installation guide so they can provide you with the right advice and set up for your particular
model of spa.
Load Shedding
Most spa pools have some form of load shedding applied as a default factory setting. Load
shedding means that the heater will turn off when your massage pumps are turned on. Your 32
amp model’s factory settings is 25 amps. We recommend leaving the default load shed setup as
it is to conserve power draw, however this can be changed by a registered electrician in the spas
electrical configuration settings.
