30
Standard
Filter 1
POWER
JET 1
UP
DOWN
LIGHT
SCREEN
JET 2
TIME
MODE
BLOWER (NA)
Standby / Power On
The spa will automatically enter standby mode when the spa is connected to power and turned
on. In standby mode, the current water temperature will appear on the LCD screen and the
thermostatic function and filtration cycle will start as per the default setting. There will be no
backlight on the screen.
Only the time button
and the on button
will be available. Press the on button
to
illuminate the screen and bring all buttons into action.
Note, the system will automatically go into standby mode and the screen light will turn off if no
buttons on the screen are pressed for one hour.
Setting the Temperature
Your spa comes with a thermostatically controlled heater. You can set the temperature from the
control panel. In standard mode, when the water temperature drops below the set temperature,
the heater will automatically turn on.
The screen will display the water temperature when the power is on. When the up button
or the down button
is pressed, the digital number showing the set temperature will flash.
You can then press the up and down buttons to change the set temperature. The temperature
can be adjusted from 10°C to 40°C. After five seconds, the digital numbers will stop flashing,
indicating the temperature has been set and will return to displaying the current water
temperature.
