4500MGB Quad Bay User Guide
Chapter 1 - Introduction / Page 2
To enter the RAID
setup menu, press
and hold the
CONFIRM button
for 3 seconds until
the three RAID
mode LEDs blink
two times. Use the
MODE button to
select the new
RAID mode and
then press the
CONFIRM button
within 10 seconds
to confirm the new
setting.
Changing the RAID
setup will require
you to re-format the
drives. Make sure
you backup all data
before doing so.
When only two hard
drives (A &B) are
installed, the
blinking LEDs for C
& D can be ignored.
Detailed View
Front View
LED indication and buttons as seen beneath the front panel of
the 4500MGB Quad Bay.
LED or
Button
Status or Function
POWER
•
OFF = Power off
•
Blue = Power on
BIG
•
Yellow = BIG mode active
(JBOD spanning)
FAST
•
Amber = FAST mode active
(RAID 0 st striping)
SAFE
•
Green = SAFE mode active
(RAID 1 mirroring)
SAFE &
FAST
•
Green & Amber = SAFE II mode active
(RAID 10 mir striping)
ERROR/
REBUILD
•
Red = Error
•
Green = Rebuilding data in SAFE mode
ACCESS
•
Blue = Ready for data access
•
Blinking = Accessing data
CONFIRM
•
To change and confirm the RAID mode
(press 3 seconds to enter setup menu)
MODE
•
RAID mode selector button
HDD
A, B, C, D
•
Green = HDD status OK
•
Blinking red & green = Error or no HDD
•
Blinking red & solid green = Data access
•
Blinking green & solid red = Rebuilding
Summary of Contents for 4500MGB Quad Bay
