Galaxy GHDXS2-1430R-16F4D Installation and Hardware Reference Manual
2-2
Safety Precautions
see
Chapter 3
for sample topologies and configuration options. Please
contact your vendor or Rorke for the list of compatible cables.
5.
SFP transceivers:
SFP transceivers must also be separately purchased.
(See
Chapter 3
)
6.
Memory modules:
If you wish to replace the pre-installed DDR RAM
DIMM module, the separately purchased module(s) must be installed.
(See
Chapter 5
)
7.
BBU:
If you wish to install a BBU, the BBU must be purchased
separately and installed prior to powering on the subsystem. (See
Section 2.8
)
8.
Rack installation:
The enclosure chassis can be installed into a rack
cabinet using separately purchased mounting rails, rear-attached
brackets, or Infortrend’s
GAL-DX-RACK-KIT
rackmount brackets.
(See
Section 2.9
)
2.3 Safety
Precautions
2.3.1 Precautions and Instructions
1.
Please read these instructions carefully.
2.
Please disconnect two (2) power cords from AC outlets before servicing
or cleaning. Don‘t use liquid or sprayed detergent for cleaning. Use a
slightly moistened paper sheet or clothe for cleaning.
3.
Rack-mounting the enclosure – The subsystem is intended to be rack-
mounted, the following concerns should be heeded when installing the
enclosure into a rack cabinet.
a.
The rack cabinet and the associated equipment at the
installation site should be able to maintain an ambient
temperature (around the chassis) lower than 40
°
C and 35
°
C if
battery backup is applied.
b.
The openings on the enclosure are for air convection through
the interior of the chassis. DO NOT COVER THE
OPENINGS.
c.
The rack cabinet into which this enclosure is installed must
support overcurrent protection and must not be overloaded by
the modules installed. Other requirements, such as ventilation
airflow, rack stabilizing features, electrical earth, and electrical
distribution, must comply with the technical specifications
listed in the documentation or safety labels that came with this
product.