Galaxy GHDXS2-1430R-16F4D Installation and Hardware Reference Manual
2-14
BBU Installation
Do not use nor leave the BBU near a heat source. Heat can melt the
insulation and damage other safety features of the battery cells,
possibly causing an acid leak and may result in a fire or explosion.
Do not immerse the BBU in water nor allow it to get wet. Its protective
features can be damaged and abnormal chemical reactions may occur,
possibly causing functional defects, acid leaks, and other hazardous
results.
Do not disassemble or modify the BBU. If disassembled, the BBU
could leak acid, overheat, emit smoke, burst and/or ignite.
Do not pierce the BBU with a sharp object, strike it with a hammer,
step on it, or throw it. These actions could damage or deform it and
internal short-circuiting can occur, possibly causing functional defects,
acid leaks, and other hazardous results.
If a BBU leaks, gives off a bad odor, generates heat, becomes
discolored or deformed, or in any way appears abnormal during use,
recharging or storage, immediately remove it from the subsystem and
stop using it. If this is discovered when you first use the BBU, return it
to Rorke or your system vendor.
2.8.2 Installation
Procedure
To install a BBU into the controller module, please follow these steps:
Step 1.
Remove the BBU slot dummy plate from the chassis
by
loosening the two (2) retention screws on the sides using a
Phillips screwdriver, and then pulling the dummy plate
away. (See
Figure 2-11
)
Figure 2-11: Removing the BBU Slot Dummy Plate
Step 2.
Install a BBU
by aligning it with the module slot, and then
gently pushing the BBU until it is fully inserted.