Galaxy GHDXS2-1430R-16F4D Installation and Hardware Reference Manual
2-16
Rackmounting
2.9 Rackmounting
WARNING!
Always use a slide, shelf or other chassis mounting hardware
to secure the Galaxy RAID in a rack cabinet.
NOTE: The front screws are not sufficient to properly hold the
chassis.
FAILURE TO PROPERLY MOUNT THE GALAXY WITH
SLIDE, SHELF OR OTHER MOUNTING DESCRIBED
BELOW MAY CAUSE DATA CORUPTION OR LOSS OF
DATA.
PN: GAL-DX-RACK-KIT
The subsystem is designed to fit into a variety of 19-inch rack cabinets or
racks. Make sure you have an appropriate site location and cables prepared
with adequate lengths to connect to main power and other devices.
Two (2) slide rails are available from Rorke for installing the subsystem into
a rack or cabinet. The available options are listed above.
Use two (2) forearm handles on the chassis ear to push or pull the subsystem
into/out of a rack. Secure the subsystem chassis to the rack using the two (2)
screw holes on each chassis ear.
To install the subsystem into a rack or cabinet, please refer to the installation
instructions that came with the slide rails.