Galaxy GHDXS2-1430R-16F4D Installation and Hardware Reference Manual
4-4
Power
On
6.
PSU LEDs:
If the PSU is operating normally and experiencing no
problem after being powered on, the LEDs on the PSU should light
green constantly.
7.
Firmware and RAIDWatch:
The overall status of the system may be
checked via the embedded firmware utility or the RAIDWatch GUI.
8.
Audible alarm:
If any errors occur during the initialization process, the
onboard alarm will sound in a hastily repeated manner.
NOTE:
The subsystem has been designed to run continuously. If a component
fails, the fault can be corrected online.
4.1.4 LCD Screen
When powering on the subsystem, wait for the front panel LCD screen to
show “
READY
” or “
No Host LUN
” before the host boots up. Refer to
Figure 4-2
on how to read the screens.
Figure 4-2: The LCD Startup Screen on the 1430R-16F4D
The LCD screen startup sequence is shown and described in the sequence
below:
This screen appears when the PSUs are
turned on.
The subsystem will start a self-test.
The self-test has been completed.
This screen appears while partner
controllers are communicating with each
other.
Initializing…
Please Wait...
Power On Self
Test, Please Wait…
RC Connecting…
Power On
Init Completed
1430R-16F4D
Model Name
Ready
Status/Data Transfer Indicator
P/S
Primary/Secondary Controller