Galaxy GHDXS2-1430R-16F4D Installation and Hardware Reference Manual
5-8
DIMM
Module Replacement
Step 1.
Remove the controller module from the subsystem
, and
place it on a clean, static-free surface. (See Section 5.2.2)
Step 2.
Remove the BBU module, if installed.
Carefully place the
module for it contains Li-Ion batteries. Do not drop it to the
floor or place it near any heat source.
Step
3. Remove the previously installed DDR RAM DIMM
module.
To remove the previously installed module, push
outward on the ejector tabs, the module will pop-up from the
socket. (See
Figure 5-6
)
Figure 5-6: Removing a DIMM Module
Step 4.
Insert the new DDR RAM DIMM module into the DIMM
socket.
Align the new module to the DIMM socket and note
how the module is keyed. Firmly press the DIMM module into
the socket making sure the module is completely seated in the
socket. The ejector tabs on each end of the socket will snap
into proper positions. (See
Figure 5-7
)