CHARGING THE GALAXY SEEKER BATTERY
X-GUARD INSTALLATION
SETUP OVERVIEW
RADIO CONTOL TRANSMITTER • BATTERY INSTALLATION
If the Radio Control Transmitter will not be
used or stored for extended periods of time,
please remove the batteries.
Please use 4 AA batteries. Use
the polarity markings to install
in the correct orientation. Do
not mix different batteries or
battery types.
Unscrew the screw
holding the battery lid
to the body. Then lightly
pull the clip down to pull
the lid away from the
transmitter body.
Insert 4xAA batteries into
the battery compartment,
making sure to match the polarities. Then replace the lid and
firmly tighten the screw to secure the battery compartment.
WARNING
CAUTION
NOTICE
Attack the X-Guards to the end of each rotor using the included small screwdriver. Place the small plastic round tabs into the holes on each
rotor arm. Firmly tighten the screws in place, making sure that the X-Guards are facing out and that the center bar of the guard is lined up
with the arm of the rotor.
1. Locate the battery underneat the unit. Carefully disconnect the power cable underneath the Galaxy Seeker as shown in the photo. Do
not pull the battery by the wires as the wires may break off of the battery housing.
CAUTION: Battery may be hot if being disconnected right after use. If hot, then wait a few minutes to let the battery coll down.
Please check the AA batteries routinely. If the AA
batteries are left within the Radio Control Transmitter,
potential leakage and/or corrosion may occur which
can damage the transmitter and create a fire hazard.
Attach the X-Guard propeller defense system.
STEP 1
Install batteries into the radio control transmitter.
STEP 2
Set the Galaxy Seeker and the monitor to charge.
STEP 3
Attach the monitor to the radio control
transmitter when charging is complete.
STEP 4
