16
Electrical Requirements
All electrical work must be completed by a registered electrician to be covered under warranty.
Depending on components, each spa pool will
require a different electrical set up. A guide for
wiring the spa pool can be located here
Installing a 10A & 15A Spa Pool
•
10 and 15 amp spas come with a 4m
power cable.
•
The power cable will be located inside
the cabinetry on the same side as your
controller.
•
By removing the panel, you will be able to
locate your power cord - it will be attached
to the frame above the control box.
•
A 10A spa requires an outdoor 10A
electrical socket. A 15A spa requires an
outdoor 15A electrical socket.
Note: It is not possible to plug a spa pool into a
10A standard house socket.
•
An RCD (Residual Current Device) should
be installed to protect the circuit and spa
pool.
Installing a 25A+ Spa Pool
•
These spas must have the electrical work
done by a qualified electrician. Galaxy
Spas is not able to provide this service.
•
Your electrician will be able to advise if
any upgrades are needed to your home’s
existing electrical set up.
Please discuss your electrical requirements
with your sales consultant. Please refer to
page 21 for spa pool power requirements.
25+ amp pools do not come with a cable plug.
The wiring of a 25+ amp pool will require
an electrician to hardwire the spa into your
power supply.
