25
Initial Start-Up Guide -
Getting your Spa Pool
Set Up for First Use
We water test every single spa at our factory, so some water residue from this testing may
remain in the pipework. It is important that you sanitise the spa prior to filling it for use.
We’ve included a Step-by-Step guide to getting
your pool ready for use for the first time below!
Step One:
•
Assemble and fit your cover lifter.
Note: Once the spa is full it will be too heavy to lift
and you will not be able to fit your cover lifter.
Step Two (in 10-15 amp spas):
•
Locate power cable in the cabinet.
•
Remove the panel that is on the same side
as your touchpad.
•
The cable will be located above the
control box. Pull it out, and reattach the
cabinet over the cable.
•
There is a small groove under the corner
panels of your cabinetry which the cord can
fit under.
•
No drilling through the cabinet is required.
A hole can be drilled into the cabinetry,
attaching a grommet if this is preferred.
Step Two (in 25+ amp spas):
•
Ensure your spa has been hard wired by a
registered electrician.
Step Three:
•
Time to fill your spa!
•
Make sure the power to your spa pool is
turned off.
•
Remove one of your filters and place your
garden hose into the filter basket (this will
help to prevent air locks in the plumbing).
Step Four:
•
Fill the spa pool to the recommended fill
line, indicated by a sticker on the inside of
your new spa.
•
Place the filter back into the filter basket.
Step Five:
•
Once full, turn on power to the spa pool.
•
A ‘priming cycle’ will automatically run,
testing the components and preparing
to heat.
•
Set your spa time and filtration cycles
(for directions on how to do this
reference the control manual found at
