STEP 4
Position the solar panel clip onto the mounting
bracket and secure into position using the screw
and nut. Do not yet tighten.
Use the timber screws to mount the solar bracket
into a position near the pelmet that attracts the
most amount of sunlight. If mounting to masonry,
use the 5mm wall plugs.
Fit the solar panel into the clip, making sure the
power cord is on the right hand side.
NOTE:
Ensure the solar panel mounting location
is close enough to allow the 2m cable to reach the
connection point on the motor.
Run the power cord along the top of the pelmet and
connect it to the motor.
Tilt the solar panel to an angle that will receive the
most sunlight, then fully tighten the screw.
STEP 5
To power up your solar motorised blind for the first
time press the motor program button once on the
right hand side of the blind. The blind will move to
the bottom position. Once it has stopped, it is ready
for use.
To program the remote control you will need to
access the program button which is located on
the inside of the remote control.
Using a Phillips-head screwdriver undo the screw
on the back of the remote control and remove
the casing. Take note of the program button.
NOTE:
The remote control is fitted with a battery
isolation tag that will need to be removed and
disposed of prior to operating the remote control.
PROGRAMMING THE REMOTE
CONTROL
Press motor
program
button once
+
+
Remote control
program button
