21
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL THE INSTRUCTIONS
CAUTION: Do not plug the power supply into a grounded outlet or do not
switch the pool cleaner “ON” if it is not fully immersed in water. Operating
the cleaner out of water will cause severe damage immediately and will
result in loss of warranty.
Allow the cleaner to remain in the pool for 15 to 20 minutes following the
end of its
cleaning cycle. This will allow the motors to cool adequately. Do not leave
the cleaner in the pool all the time. Always remember to turn the power
supply “OFF” and unplug it from the power outlet before removing the
cleaner from the pool.
WARNING: The cleaner must not be used when people are in the
water. For use with swimming pool only
Safety Note
- The unit must be supplied through a residual current device (RCD)
having a rated residual operating current not exceeding 30 mA
- The connection to the branch circuit should be consistent with the local
and national wiring rules (electrical code).
- Mishandling of the unit can result in leakage of lubricants.
- If the supply cord is damaged, it must be replaced by the manufacturer’s
service agent or a qualified and trained person in order to avoid hazards.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
WARNING: A Ground Fault Current Interrupter (GFCI-USA) or a
Residual Current Device (RCD-EUROPE) must be installed to protect
your electric outlet and prevent any possible electric shock.
SAVE THESE INSTRUCTIONS
Dear Customer,
Thank you for choosing our product to clean your pool. We hope that you
will enjoy using your new robot to maintain your swimming pool for years
to come. Before you begin to use your robot, please take a few minutes to
carefully read these operating instructions. Again, thank you for choosing our
product
Components
While the appearance of your cleaner and some of its components
may differ from those shown here, the function of the cleaner, operating
procedures and maintenance practices are the same.
Your new automatic pool cleaner contains:
- The robotic pool cleaner with its floating cable.
- The Power Supply (transformer).
- Cart (optional)
- Adjustable handle is not a part of Galeon FL
Please read this manual completely before operating your pool cleaner.
Handle
Unit Body
Scrubbing Brush
Outlet Top
Handle Lock
Mechanism
Side Plate
Drive Track
