Galileo G-860WG, Instructions Manual

5

GALILEO G-860WG

ASSEMBLY INSTRUCTIONS

1. 

2. ADJUST  TRIPOD  TO  PROPER  HEIGHT  BY  LOOSENING,  
    ADJUSTING  AND   TIGHTENING THE LOCKING KNOBS.

3. REMOVE TELESCOPE AND MOUNT FROM CARTON.
    NOTE: THEY COME PRE-ASSEMBLED FROM THE FACTORY.

4. LOOSEN MOUNTING KNOB ON THE TELESCOPE 
    MOUNT (UNDERNEATH)

5. PLACE THE TELESCOPE AND MOUNT ASSEMBLY 
    ONTO THE TOP OF THE TRIPOD.

6. TIGHTEN LOCKING KNOB (UNDERNEATH THE TRIPOD TOP) SECURELY.

8. ATTACH ELECTRONIC MARS-EYE FINDER.

9. USE  THE  TWO  THUMB  SCREWS  TO  POSITION THE
    ELECTRONIC MARS-EYE FINDER ON THE  TELESCOPE  
    TUBE.  FOR  ADDITIONAL  HELP  SEE THE PAGE IN YOUR
    INSTRUCTION  BOOK FOR ELECTRONIC MARS-EYE  FINDER
    MOUNTING AND ALIGNMENT.

REMOVE PRE-ASSEMBLED TRIPOD

CAUTION:  NEVER POINT YOUR TELESCOPE 
AT  THE   SUN.  VIEWING   THE  SUN    WITH 
THIS  TELESCOPE  OR  EVEN THE  UNAIDED
EYE CAN RESULT IN BLINDNESS OR OTHER 
SERIOUS  EYE  DAMAGE.

7 ATTACH ACCESSORY TRAY  AS SHOWN.

.

WASHER

KNOB

IF YOU NEED ANY FURTHER HELP WITH YOUR GALILEO TELESCOPE
       PLEASE CALL US @ 305-245-8444 MON-FRI 9AM - 5PM E.S.T
     OR E-MAIL US AT CUSTOMERSERVICE@COSMOSOPTICS.COM