GALILEOSKY GLONASS/GPS Satellite v4.0 (0223) User’s manual
GalileoSky Ltd.
Page 64
Command format
EraseTrackSD
Explanation
Deleting all tracks from the SD memory
Example
Request: EraseTrackSD
Reply: ERASETRACKSD
Command format
ColdStart
Explanation
GLONASS unit cold start.
Example
Request: ColdStart
Reply: GLONASS cold start
Command format
Reset
Explanation
Allows resetting the device remotely.
Example
Request: Reset
Reply: Reset of device. Please wait 15 seconds…
Command format
Upgrade
Explanation
Firmware upgrading up to the specified one.
Example
Request: Upgrade 47
Reply: UPGRADE 47
Command format
SleepMode OffOnStop,DST,GNSS,GPRS,ADC,CAN,0,RS485,SD,WakeUp,ST
Parameters
OffOnStop
– 0 – do not turn off GPS\GLONASS unit at a stop;
1 – turn off GPS\GLONASS unit at a stop.
DST
– Time spent at a stop, after which the Terminal will switch to the deep sleep
mode;
GNSS
– turn off GPS\GLONASS unit in the deep sleep mode;
GPRS
–turn off GSM unit in the deep sleep mode;
ADC
– reduce ADC sampling rate in the deep sleep mode; the maximum
frequency that can be measured at inputs is reduced by 2 and the minimum
impulse period that can be registered increases twofold;
CAN
– turn off the CAN in the deep sleep mode;
RS485
– turn off RS485 in the deep sleep mode;
microSD
– turn off the microSD card in the deep sleep mode, the reading of
trusted iButton keys is supported;
WakeUp
– a period in seconds between connections to a server ;
ST
– a length of connection to a server in deep sleep mode.
Explanation
Power saving modes control. In the deep sleep mode no 1Wire sensors sampling
and no battery charging are performed.
Example
Request: SLEEPMODE 1,60,1,1,1,1,0,1,1,3600,600
Reply: SLEEPMODE:OffGNSSOnStop=1,DSTimeout=60,
GNSS=1,GPRS=1,ADC=1,CAN=1,RS232=0,RS485=1,SD=1;GSMWakeUp=3600,
SessionLen=60.
Command format
RemoteConfig OnOff
Parameters
OnOff
– turns on the remote configuration function:
0 – remote configuration is off;
1 – remote configuration is on.
Explanation
Turns on and off the remote configuration (See section Remote configuration).
Example
Request: RemoteConfig
1
Reply: REMOTECONFIG:1;
