User’s Manual GalileoSky GPS Lite (0192)
GalileoSky Ltd
Page
26
Command mode tab
This tab is intended to run single command or a set of commands.
The command mode has the following buttons:
1)
Run commands;
2)
Run single command;
3)
Open from file;
4)
Save to file.
The commands will be identified whether you use capital or lower-case letters or both in turn.
Attention!
There are no spaces in command name!
Spaces between parameters are not allowed!
Commands and parameters are separated by space.
Commands are separated by Enter.
Single command example
An example of a parametric command
Enter APN internet.beeline.ru,beeline,beeline as shown on the figure above and press
Run single command
. The command and response will be displayed in the Responses window.
Command: APN internet.beeline.ru,beeline,beeline
Response
:
GPRS: APN=INTERNET.BEELINE.RU, user=BEELINE, pass=BEELINE
To access parameters in the device memory you should use a command without parameter!
A example of command without parameter:
"APN" command
Request:
APN
Response:
GPRS:APN=INTERNET.BEELINE.RU,user=BEELINE,pass=BEELINE
