Galiso HDD-8RB, Installation/Operation Instruction Manual

Section 5 – 2 

21-11-1025 

5.0 OPERATION, continued

G.  The Operation Indicator will flash green while in operation. 

H. Zone Indicator will always display 1. Only one zone has been programmed for 

this Controller. 

I.  The Reset Button  

 will only be used if over-temperature has been reached.

NOTE:

 An Over-temperature monitor has been installed to prevent this system from 

overheating. If temperatures are over reached, the system will shut off the Heater and 

an error message will be shown. Pressing Reset 

 will restart operation, if the 

temperature has not exceeded the target pressure. 

J.  The following Buttons are only used for programming purposes;  

E Z

. For 

any problems or programming questions, please contact Galiso

®

, Inc. At 1-800-

854-3789. 
 

K. After cylinders have been drying for a short time (5-10 minutes), check each 

cylinder for dryness, and replace on the dryer if necessary or, load the next 
cylinder. 

NOTE:

 Cylinder dry times can vary, depending on the size and/or material. Galiso, Inc. 

recommends using low temperature settings for composite cylinders. 

! CAUTION ! 

The dryer can remain “On” when changing out cylinders but the 
operator should be careful to avoid touching the Manifold Frame, 
as it may be hot. Also, Always wear Insulated Gloves when 
removing the Probes. 

L.  To shut down at the end of the day, flip the Power Switch to the “OFF” position. 

6.0 MAINTENANCE

A.  No regular maintenance is required except to check the air filter on top of the 

muffler at least once a month and replace if needed.