28.
General log only system errors
Errors 80 through 89 are general system errors. They are logged only; they do not cause the
system to crash.
80
Grade 1 Front Preset Overrun
This indicates that the delivery on the Grade 1 Front hose did not stop at the preset or allocation
limit. When this happens, the cutover point at which slow flow is entered automatically adjusts to
compensate.
Note the difference from the encoder run-on error: encoder run-on is a continued flow after the
end of delivery state has been reached, whereas preset overrun indicates that the end of delivery
state was not reached in time to prevent excess fuel being delivered.
81
Grade 1 Rear Preset Overrun
This indicates that the delivery on the Grade 1 Rear hose did not stop at the preset or allocation
limit.
82
Grade 2 Front Preset Overrun
This overrun error indicates that the delivery on the Grade 2 Front hose did not stop at the preset
or allocation limit.
83
Grade 2 Rear Preset Overrun
Error 83 indicates that the delivery on the Grade 2 Rear hose did not stop at the preset or
allocation limit.
84
Grade 3 Front Preset Overrun
This indicates that the delivery on the Grade 3 Front hose did not stop at the preset or allocation
limit.
85
Grade 3 Rear Preset Overrun
This indicates that the delivery on the Grade 3 Rear hose did not stop at the preset or allocation
limit.
86
Lost Reply (Console)
A Lost Reply error indicates that the pump comms are trying to reply to a poll from the Console,
but did not succeed in sending a reply within 4 clock ticks (0.08s) of receiving the poll message.
This means that the main loop tasks (other than comms) are taking up too much processor time, so
that the comms do not get serviced often enough.
87..99 Not used
These error codes are reserved.
Summary of Contents for Apollo 3000
