3E2374 Sheep Auto Drafter User Manual
Page 33
To weigh and draft animals (draft by weight)
1.
Set up the scale indicator so it is ready to weigh animals automatically and
specify the weight limits for each group.
2.
Press the green Start button
on the remote control or press the Entry
Gate button on the Control Bridge for 2 seconds or more.
•
The white LED mode lamps will now be on to indicate that you are in
Automatic Release Mode.
•
The entry gate will open. When a sheep has entered the entry gate
will close to capture it. Once the sheep has been successfully
weighed the scale indicator will beep. The scale indicator will display
both the animal's weight and the direction it will be drafted in. The
exit gate will open and the sheep will be drafted according to the
conditions set up in the scale indicator.
To read EIDs
1.
Connect the loop back cable into the socket on the Control Bridge, instead
of the scale indicator, so that the load cells are not connected.
To find out how to do this see
Using without a scale attached
(p 38).
2.
Set up the scale indicator to read EIDs. Make sure the RFID reader is also
attached.
3.
Press the green Start button
on the remote control or press the Entry
Gate button on the Control Bridge for 2 seconds or more.
•
The white LED mode lamps will now be on to indicate that you are in
Automatic Release Mode.
•
The entry gate will open. Once a sheep has entered the entry gate will
close to capture it. When the EID has been successfully read the exit
gate will open and the sheep will be released.
To read EIDs and draft by list (not weighing)
1.
Connect the loop back cable into the socket on the Control Bridge, instead
of the scale indicator, so that the load cells are not connected.
To find out how to do this see
Using without a scale attached
(p 38).
2.
Make sure the RFID reader is connected. Set up the scale indicator to read
EIDs and select a draft list.
3.
Press the green Start button
on the remote control or press the Entry
Gate button on the Control Bridge for 2 seconds or more.
•
The white LED mode lamps will now be on to indicate that you are in
Automatic Release Mode.
•
The entry gate will open. Once a sheep has entered the entry gate will
close to capture it. When the EID has been successfully read the exit
gate will open and the sheep will be drafted according to the
conditions set up in the scale indicator.
Summary of Contents for HR3
Page 1: ...SHEEPAUTODRAFTER Instructions ENG...
Page 4: ...Page iv 3E2374 Sheep Auto Drafter User Manual Index 49...
Page 48: ......
