English
Gallagher 3E4345 MBS1000i MBS1800i MBS2800i Energizer User Manual
15
Current Alarm
The factory default se ng is current alarm disabled (shown by --). To improve
your ability to
fi
nd faults before your fence becomes ine
ff
ec ve (voltage too low),
Gallagher recommend se ng the current alarm 10A above normal opera on.
Many events can cause the current to increase, including rainfall, grass growth,
broken fences and failed insulators. If the current goes above the alarm level you
have set, then the Energizer icon ( ) will
fl
ash and the status LED will
fl
ash red.
Controller showing the energizer in current alarm
Status LED
fl
ashes red
Adjus ng / Turning Off Alarms
a)
Press the setup bu on (
).
b)
Press the naviga on bu ons (< or >) to move the zone indica on arrow (
)
over the desired zone, which will
fl
ash when selected.
c)
Press (- or +) to adjust the zone alarm level.
d)
To disable an alarm press (-) un l the display shows (- -).
e)
To exit, press the setup bu on (
) or wait 10 seconds.
Controller showing the default energizer alarm setup with
current disabled and voltage at 3.0KV
