ESTRO GT
6
FC66003937 - Rev 00
ALL COPYING, EVEN PARTIAL, OF THIS MANUAL IS STRICTLY FORBIDDEN
2
MODELS AND CONSTRUCTIVE COMPONENTS
GTFP Ceiling mounted
>
Cabinet composed of a steel
sheet panel (thickness 10/10
mm), side panels and air outlet
grille (swinging by 180°) built
from ABS. The side doors
make it possible to access the
technical compartments and the control panel (accessory).
>
Bearing structure built from thick galvanised steel sheet (thickness
up to 15/10 mm), insulated by means of Class 1 self-extinguishing
panels.
The unit is supplied complete with a double condensate collection
and drainage system; in case of horizontal installation, condensate is
collected in a capacious drip tray.
> High efficiency heat exchanger made with copper piping and
aluminium fins blocked to pipings by mechanical expansion, provided
with brass manifolds and air vent valve. The heat exchanger usually
comes with water connections mounted on the left, but it can be
turned by 180°.
>
Permanent magnets electric synchronous motor (GT) mounted on
vibration damping supports, complete with sinusoidal inverter board.
>
Double suction centrifugal fans, statically and dynamically balanced,
directly connected to the electrical motor, made with antistatic ABS,
with blades having an airfoil section and offset modules.
> Honey-comb polypropylene washable air filter, mounted on a
galvanised sheet frame protected by a net, easily removable for
maintenance operations. The filter is secured to the cabinet with 1/4-
turn screws.
GTFC Vertical / horizontal recess
mounted
> Bearing structure built from
thick galvanised steel sheet
(thickness up to 15/10 mm),
insulated by means of Class
1 self-extinguishing panels.
The unit is supplied complete with a double condensate collection
and drainage system; in case of horizontal installation, condensate is
collected in a capacious drip tray.
> High efficiency heat exchanger made with copper piping and
aluminium fins blocked to pipings by mechanical expansion,
provided with brass manifolds and vent valve. The heat exchanger
usually comes with water connections mounted on the left, but it can
be turned by 180°.
>
Permanent magnets electric synchronous motor (GT) mounted on
vibration damping supports, complete with sinusoidal inverter board.
>
Double suction centrifugal fans, statically and dynamically balanced,
directly connected to the electrical motor, made with antistatic ABS,
with blades having an airfoil section and offset modules.
> Honey-comb polypropylene washable air filter, mounted on a
galvanised sheet frame protected by a net, easily removable for
maintenance operations.
GTFF Vertical / horizontal recess
mounted
> Bearing structure built from
thick galvanised steel sheet
(thickness up to 15/10 mm),
insulated by means of Class 1
self-extinguishing panels.
The unit is supplied complete
with a double condensate
collection and drainage system; in case of horizontal installation,
condensate is collected in a capacious drip tray.
> High efficiency heat exchanger made with copper piping and
aluminium fins blocked to pipings by mechanical expansion, provided
with brass manifolds and air vent valve. The heat exchanger usually
comes with water connections mounted on the left, but it can be
turned by 180°.
>
Permanent magnets electric synchronous motor (GT) mounted on
vibration damping supports, complete with sinusoidal inverter board.
>
Double suction centrifugal fans, statically and dynamically balanced,
directly connected to the electrical motor, made with antistatic ABS,
with blades having an airfoil section and offset modules.
> Honey-comb polypropylene washable air filter, mounted on a
galvanised sheet frame protected by a net, easily removable for
maintenance operations. The filter is secured to the cabinet with 1/4-
turn screws.
