© Copyright
Gallo Technologies
. All Right Reserved
- 7 -
Rev. V8.2- 20212
Disabled:
When the key FOB is within range, and the system is in disarm mode, the lights will flash 2 times. The
“Push Start Stop”
button is activated when the door is opened. The green LED will flash slowly. The siren will not
chirp.
When the key FOB is out of range, the doors will not lock and the system will stay in Disarm mode. The lamps will
flash once when the door is closed and the siren will not sound. ACC will turn OFF and the
“Push Start Stop”
button will be disabled.
NOTE: When the key FOB is out of range and “Auto door lock / unlock” function is disabled, the doors can be
locked/unlocked and the system armed/disarmed by pressing either key FOB button
(arm button) or
(disarm
button).
2. Automatic / Manual Transmission
:
Automatic Transmission (default):
Manual Transmission (optional):
See
Figure 1. Option 4
for wiring requirements.
3. Silent Arm/Disarm:
Enabled (default):
Siren does not chirp when locking / unlocking the doors.
Disabled:
Siren chirps when locking / unlocking the doors.
4. Foot-Brake lock/unlock:
Enabled (default):
15 seconds after starting the engine the doors will automatically lock when the foot brake is
pressed. Doors will automatically unlock when the engine is turned OFF.
Disabled:
After starting the engine the doors will not automatically lock.
5. Auto Rearm:
Disabled (default):
The system will not automatically rearm and relock itself after the system is
disarmed
by
pressing
, if the door is not opened.
Enabled:
The system will automatically rearm and relock itself within 30 seconds after the system is disarmed by
pressing
, if the door is not opened.
6. Electrical Siren/ Horn:
Electrical Siren (default):
Set if the 6 tone siren (included) is used.
Horn:
Set if the vehicle’s horn is to be used instead of the 6 tone siren. An additional relay may be required. The
control module siren output is a low current output and must go through a relay to operate a vehicle’s horn.
7. Central Locking Time:
When pressing
or
the electrical pulse sent to the door locking/unlocking
mechanism can be set at either 0.8 seconds or 4 seconds. Most cars will function properly when this option is set to
the factory default of 0.8 seconds.
Enable (Default):
.8 sec pulse
Enable (option):
4 second pulse
8. Door Unlock Pulses:
Some vehicles require 1 unlock pulse to unlock the driver’s door only and a second pulse
to unlock all doors. Most vehicles only require 1 unlock pulse (Default setting) to unlock all doors.
Enable (Default):
1 unlock pulse. Set to unlock drivers door only in 2 pulse vehicles then press
to unlock all
doors. Also set for vehicles requiring only 1 pulse to unlock all doors.
Enable (option):
2 unlock pulses. Set to unlock all doors in vehicles requiring 2 pulses.
9. Door Open Light Flashing:
Disabled (default):
The parking lights will not flash when a door is opened.
Enabled:
The parking lights will flash 2 times when a door is opened.
