-5-
1
WAIL
(Wail default) §, *,
†
2
YELP
(Yelp default) §, *
3
THUNDER
(THUNDER default)
4
TWO-TONE
(THUNDER Step Up
default)
5
MECHANICAL WAIL
(FIRE ENGINE)
†
7
HOOT
8
RAPID HOOT
9
AIR HORN & YELP
10
GHOST
11
RAPID GHOST
12
SINGLE AIR HORN
13
SINGLE QUICK
14
DOUBLE POST POP AIR HORN
15
TWO TONE AIR HORN
16
STANDARD AIR HORN
Tones For WAIL, YELP, and
THUNDER, and Thunder Step-Up
Function
§
= SAE approved
* = California Title 13 approved
†
= See below
6
MAX YELP
§, *
17
CONTINUOUS TONE
18
CONTINUOUS BEEP
Tones For MANUAL Button & AUX Wire
1
STANDARD AIR HORN
(AUX default)
2
LOW FREQUENCY AIR HORN
3
RAPID AIR HORN
4
AIR HORN II
5
DOUBLE POST POP AIR HORN
6
SINGLE AIR HORN
7
SINGLE QUICK AIR HORN
8
TWO TONE AIR HORN
9
MANUAL
(MANUAL default) *
10
MECHANICAL MANUAL
(FIRE ENGINE)
Tones for HORN Button
1
STANDARD AIR HORN
(default)
2
LOW FREQUENCY AIR HORN
3
RAPID AIR HORN
4
AIR HORN II
5
DOUBLE POST POP AIR HORN
6
SINGLE AIR HORN
7
SINGLE QUICK AIR HORN
8
TWO TONE AIR HORN
►►►►
System Reset
◄◄◄◄
If you would like to reset ALL of the siren programming
options to their defaults, activate any tone and press
the
Program button
for nine (9) seconds. The LED will
flash once, then twice, then three times, and all siren
tones will stop.
Wind Down or Hard Stop Option
By default, the Wail tones indicated by the “
†
” above will “wind down” when they
are de-activated. If you prefer to have them immediately stop (i.e. hard stop), hold
the Program Button for 3 seconds (until the LED flashes once). This will change it to a
hard stop. Repeat to change back to the wind down option.
(Installer Selectable Options CONT’D)
Optional Tones
Tone Disable Option
Some municipalities may ban the use of specific tones, such as the
Thunder
tone.
The
Thunder Disable
jumper option (found in our previous versions of the ST240) has
been replaced with the
Optional Tone Programming
feature described on the
previous page. This will allow you to reprogram the
THUNDER
default tone from
Thunder
to any of the other tones listed. This new feature expands the former option
(that was previously limited only to disabling the Thunder tone) to the ability to
replacing ANY of the tones that may not be permitted (or desired).
Auxiliary-Manual Function Option
By default, when the siren is in
THUNDER
,
YELP
, or
WAIL
modes, and the AUX function
is activated (typically by the steering wheel horn relay), the siren will produce the
standard Air Horn Tone (#1 in the chart above) and temporarily override the siren
tone. If you would rather have the AUX function (i.e. steering wheel horn) mimic the
MANUAL button
(see MANUAL button functions on page 7)
,
then you should
program the AUX function for tone #9 (Manual) or #10 (Mechanical Manual).
