© All rights reserved - Galmet Sp. z o.o. Sp. K.
Installation and Operating Manual - SGW(S) Vulcan
11
5. Titanium, maintenance-free, active anode
5. Titanium, maintenance-free, active anode
5.1. Pros of the titanium anode
- reliable, durable protection
- low consumption of anodes
- no sludge on the anode
- not required regeneration
- guaranteed long-term operation of the tank
1. Titanium anode
2. Potentiostat (AC)
3. Grounded cord
NOTE ! Before installing the anode CORREX, remove existing protective magnesium anode.
1. Cable supplied bipolar, connecting the anode CORREX and potentiometer plug must not be lengthened.
2. A random change in polarity causes the acceleration of corrosion.
3. It is recommended to use the socket 230 V in a short distance from the tank.
5.2. Troubleshooting
LED CONTROL
CAUSE
METHOD OF REMOVAL
ON - green colour
-
Anode CORREX working properly. Full
protection against corrosion.
-
OFF
-
Lack of electricity.
-
Check the voltage 230 V.
ON - red colour
-
Lack of water in the tank.
-
Cables between the electronic part and the
anode is connected incorrectly.
-
Lack of contact between the ground (tank)
and the electrical part of the anode.
-
The anode is contacted with the mass of
the tank.
-
Fill the tank with water.
-
Put the cables at the anode.
-
Check and clean the rust all connections.
-
Properly isolate the anode from the tank.
